PC Mover Move applications, files and settings from one PC to another. Handles Windows upgrades too, even XP 32-bit to Windows 7 64-bit!
Partition Commander Now it's easy for anyone to safely partition their hard drive! You can reclaim waste disk space, organize files, even add new OSes.
Fix-It Utilities Make your PC run like new! Includes Anti-Virus, Anti-Spyware, hardware diagnostics, registry fixer, and more!
The Plug and Play (PnP) manager could not be initialized.
The Plug and Play manager is used to handle adding hardware to your system like printers, USB devices, etc. If it does not start up, you may not have access to some of your peripherals.
This is a fatal Windows error, typically called a Stop message, Bug Check, or more commonly the Blue Screen of Death (BSoD). The system is in a forced reboot state. Any unsaved work is likely lost.
A problem has been detected and Windows has been shut down to prevent damage to your computer.
If this is the first time you've seen this Stop error screen, restart your computer. If this screen appears again, follow these steps:
Check to make sure any new hardware or software is properly installed. If this is a new installation, ask your hardware or software manufacturer for any Windows updates you might need.
If problems continue, disable or remove any newly installed hardware or software. Disable BIOS memory options such as caching or shadowing. If you need to use Safe Mode to remove or disable components, restart your computer, press F8 to select Advanced Startup Options, and then select Safe Mode.
*** STOP: 0x00000090
Beginning dump of physical memory
Physical memory dump complete.
Contact your system administrator or technical support group for further
Text may appear differently depending on where the error occurs.
Additional technical information (hex values) specific to a machine are not shown.
If the BIOS is current, it's possible bad BIOS parameters are causing the problem, especially if the memory or CPU settings are overclocked. The BIOS parameters are stored in CMOS memory. The best way to reset the BIOS parameters is to remove the CMOS battery. To do this:
Unplug the PC, and open the case.
Locate the battery on the motherboard - typically a silver coin cell.
Remove the battery and note if the plus side is up or down, so you can reinstall it later the same way.
Wait at least 1 minute and reinstall the battery.
Attach power and power up. Typically a BIOS warning message will indicate CMOS was corrupted or changed and it may require you to go into the BIOS setup to set the time and date.
Proceed to boot Windows and see if this fixes the issue.
Some BIOSes have options to enable/disable caching and/or shadowing. If the options are available, disable caching and shadowing. Most newer (2005+) systems do not have these options. There are many BIOS makers and customized versions of the BIOS, so you may have to enter BIOS setup and look a bit to find these options. Typically you press a key like Esc, Del, F1, or F2 before Windows starts (almost right after you reboot) to enter BIOS setup. Consult your computer manual for details. The setup key can also be found in our BIOS access list.
FaultWire Staff Posted: 5-Oct-2008
Get the Latest Drivers
Check if you are using the latest hardware drivers, especially the chipset and video drivers. Older drivers are a common contributor to BSoD issues.
You can use a product like Driver Genius or Radar Sync to verify you have the latest drivers and help keep all your drivers up-to-date. If you're comfortable with driver installations, you can individually find and install current drivers.
While BSoD fatal stop errors are identified by Microsoft Windows, they are often caused by
non-Microsoft applications, drivers and hardware issues.
Research this Issue
Getting search results...
While we believe this information up to date and accurate, FAQware is not responsible for any inaccuracies. If you find something that is out of date or inaccurate, please let us know at
so we can correct it.